Structure and Hardware Parameters of Colorlight 5A Products Series

S/N

Name

Function

Remarks

1

Power-in 1

Connect DC5V power supply to power the receiving card.

Only one is used.

2

Power-in 2

Connect DC5V power supply to power the receiving card.

3

Net port A

RJ45, for transmission of network signals

The dual net ports can achieve import/export at random, which can be identified in an intelligent way by the system.

4

Net port B

RJ45, for transmission of network signals

5

Indicator light

It indicates the status of power and signal transmission.

Red for power, green for signals

6

Peripheral ports

For Indicator light and test buttons

Two kinds of interface definitions

7

Relay port

The cabinet fan power can be controlled through the relay.

To be customized

8

Flash

2Gbit memory chips can be soldered to store offline contents

5AF version

9

Dual 50P pins

Connected to all display HUB boards

10

Test buttons

The attached test procedures can achieve four kinds of monochrome display (red, green, blue and white), as well as horizontal, vertical and other display scan modes.

11

Temperature sensor port

Temperature probes can be soldered to detect the temperature of each card.

To be customized

Full Color

Function

Note

2, 4, 47, 49

VCC 5V

Power

1, 3, 5, 46, 48, 50

GND

Ground

10, 14, 18, 22, 26, 30, 34, 38

R

Data signal

8, 12, 16, 20, 24, 28, 32, 36

B

9, 13, 17, 21, 25, 29, 33, 37

G

7, 11, 15, 19, 23, 27, 31, 35

RP (red virtual pixel)

45

OE

Control signal

43

LAT

44

CLK

42

A

Scan signal

41

B

40

C

39

D

6

Expansion port

S/N

Name

Function

Remarks

1

Net port A

RJ45, for transmission of network signals

The dual net ports can achieve import/export at random, which can be identified in an intelligent way by the system.

2

Net port B

RJ45, for transmission of network signals

3

D5，D6

If D5 is welded but D6 not, the input voltage will be 6V ~ 45V, and if less than 6V, the system does not work; if D6 is welded but D5 not, the input voltage will be 5V, ± 10%, and if too high voltage, the system will be burned.

Only one of the two shall be welded.

4

Power-in

To power the receiving card

5

Indicator light

It indicates the status of power and signal transmission.

6

Test buttons

The attached test procedures can achieve four kinds of monochrome display (red, green, blue and white), as well as horizontal, vertical and other display scan modes.

7

Temperature sensor port

Temperature probes can be soldered.

8

Signal output port J2

Two groups of parallel RGB output or 6 groups of serial signals

Only J1 or J2 is to be connected.

9

Signal output port J1

Four groups of parallel data or 16 groups of serial output