Support

Computer To Control Multiple displays (Send Card)

I. Description


Scene three different sizes, different screen sizes LED1, LED2, LED3.

Three display area, respectively

LED1: 16 full color sweep 384 * 256 pixels;

LED2: 8 Esau full color 256 * 256 pixels;

LED3: static full color 128 x 256 pixels.

Program contents are displayed on three different display.

Demand: Using a computer, send a card, while controlling the three display!



Effect diagram (Figure 01)



II, the hardware device

Required hardware equipment:

One computer;

Send a card;

Colorlight receiver card (T9, A8,5A here can be used as a controller card, for example, this article is 5A);

Gigabit Switch (optional)



III, the software settings

1, the configuration screen parameters

Separately for each piece of LED display parameter settings, save the parameter file LED1.rcvp;. LED2 rcvp;

LED3. Rcvp. (Specific parameter setting procedure, refer to "5A receiver card commissioning steps")

2, set the number of screens

Open the "Control Screen" → "Screen Management" to enter the screen management interface, set the number of screens to "1." At this time,

Software is only a LED screen.



Set interface (Figure 02)



3, the loading screen parameters

Send a copy of the card is used in desktop mode, you need three LED display in a different area, by receiving a card connection settings change each screen coordinates.

The computer and the first piece of the LED display with a net line directly connected, click on the software's "Screen Management" in the "Configuration select screen parameters", "password" 168 ", enter" receiving card parameter settings "screen, click" file Load "Load the first step to get the" LED1. rcvp ", and" Send to receive the card.

Click image to look Big Image

Loading parameters (Figure 03).



Disconnect the network cable, connect LED2, loading parameters, modify connection settings, right LED1 width, sent to the receiver card.

Click image to look Big Image

Connection settings (Figure 04)


Disconnect the network cable, connect LED3, loading parameters, modify connection settings, right LED1 and LED2 total width, sent to the receiver card.

Note: A. loading screen parameters of the process, the computer must be loaded with an LED display parameters are directly connected, other

LED display of the network cable must be disconnected.


IV, the hardware connection

Kalai Te control system software is set up, the hardware connection is quite flexible, customers can according to the construction site

The actual hardware connection environment, mainly in the following three options after the summary.

A. series


Serial diagram (Figure 05)



B. Parallel



Parallel diagram (Figure 06)



C. Even mixed


Even mixing diagram (Figure 07)

VEdit the program

As long as players in the specified location corresponding program, the display will be able to display properly.

You can build an LED, add different program windows, you can create different LED tablecloth.


colorlight led control card solution download


CATEGORIES

    CONTACT US

    Contact: Lee

    Phone: +86-132-6566-7728

    E-mail: info@colorlitled.com

    Add: Tangtou Industrial Park,Shiyan,Baoan,Shenzhen